EchoStar ad-3000 ip Manuale Utente
7
Make sure you write your Television code in the boxes on page 10 and in the battery
compartment for easy future reference.
compartment for easy future reference.
Important note: To blink back the code for your Video Recorder, follow the instructions above
only press VCR during step 1.
only press VCR during step 1.
4.1
To set-up a second EchoStar Satellite Receiver
To set up a second EchoStar Satellite Receiver on the VCR key follow the instructions
below:
below:
1.
Press and hold the SAT key until the red light stays on. Release the SAT key (the light
will start flashing). Now press 9 9 2 followed by the VCR key once (the red light will
blink twice).
will start flashing). Now press 9 9 2 followed by the VCR key once (the red light will
blink twice).
2.
Find your EchoStar code in the set-up code section. Codes are listed by model number.
Make sure your EchoStar receiver is switched on.
Make sure your EchoStar receiver is switched on.
3.
Press and hold down the VCR key until the red light stays on. Release the VCR key (the
light will start flashing).
light will start flashing).
4.
Enter your four-digit Satellite code. The red light will blink three times, confirming the
new code is loaded successfully.
new code is loaded successfully.
5.
Now, aim the Tri Control at your EchoStar receiver and press POWER. If your Satellite
receiver switches off, your Tri Control should be ready to operate your EchoStar Satellite
Receiver.
receiver switches off, your Tri Control should be ready to operate your EchoStar Satellite
Receiver.
If you want to set-up a second EchoStar Satellite Receiver on the TV key. Follow the instructions
above, only press TV instead of VCR during steps 1 and 3.
above, only press TV instead of VCR during steps 1 and 3.