EchoStar d-2510 ip viaccess Manuale Utente

18

Press the MENU key to display the “Main Menu”   o
n the screen.

Select a sub-menu using the  ,   keys or  the numeric k
eys. Please note that the OK key is always  a confirma
tion of your selection.  To go back to the previous me
nu, press the  MENU key.

The Installation Lock “Enter PIN code” menu is displayed only when the Installation and Edit  Lock is se
t as [ON]. The initial code is set as [0000] but you can change it (See “Change PIN code” on page 20).

In some cases it might be necessary to reposition all satellites at once. This can be achieved with the “Re-align di
sh”option.

You can move the dish using the  ,   keys when the “Position” option is selected. . To locate a satellite move the
dish until you have the location of the satellite at which the best signal quality is achieved. Press the OK key wh
ile still on the “Position” option to store the position. The stored locations for each satellite are shown above the
Signal Level bar.
If you are unable to get any signal quality, please check the LNB Setting to ensure you have selected the correct
LNB and switch settings.

This menu is to align your dish to the selected satellite.
If you set the “Polarity Control” parameter in the “LNB
Setting” menu as “Polarotor” or “Ferrite”, you can adjust
the “Skew” parameter in this menu while you are watchi
ng the signal level at the same time.

Refer to the Signal Quality bar and the Signal Lev
el bar at the bottom of the screen. It is recommend
ed that the signal is at the Medium level or higher.
If it is not , please adjust your satellite dish.