Yamaha gx-5 Manuale Proprietario

•

When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.

•

The automatic recording level control circuit automatically
controls the level of the input signal used for recording.

•

Adjusting the VOLUME control and using the built-in
sound field processor have no effect on the recorded
sound.
If, however, the built-in graphic equalizer is used, its effect
is recorded along with the source.
* Music with an equalizer effect is suitable for listening to

inside a car etc.

•

For the tape deck, the deck which can be used for
recording is the DECK B only. When recording, be sure to
load a tape into the DECK B cassette compartment.

Press the CD input selector button and load the disc to be
recorded.

Load a tape into the DECK B cassette compartment.
*

Wind past the beginning part of the tape on which
recording cannot be performed.

When recording with the Dolby NR system, select the
Dolby NR B or C position by pressing the DOLBY NR
button. If not, set it off.
*

For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 23.

If desired, switch the reverse mode by pressing the
reverse MODE selector button.

When the tape is set so that side A faces you, recording will
be done as follows automatically according to the selected
reverse mode.

Press the REC/PAUSE button.
*

The corresponding indicator will light up and the play
direction indicators flash.

Start CD playback by pressing the corresponding disc
select button, or by pressing the play/pause button if the
disc is already selected.
*

Before CD playback begins, recording automatically
begins on the side of the tape now selected.

Side A only

Side B only

Side A 

→

SideB

Side B only