Yamaha RX-Z11 Guida Utente

Use this feature to store the desired FM and AM stations manually.
You can also store up to 40 stations (A1 to E8: 8 preset station 
numbers in each of the 5 preset station groups) manually.

Tune into the desired station.
See pages 68 and 69 for tuning instructions.

Press J

MEMORY (or 0MEMORY).

The MEMORY indicator flashes in the front panel display for 
approximately 10 seconds.

M

PROGRAM (or 9A-E l / h) repeatedly to 

select a preset station group (A to E) while the 
MEMORY indicator is flashing.
The selected preset station group letter appears. Check that the 
colon (:) appears in the front panel display.

M

PROGRAM (or press 9PRESET/CH k / n 

repeatedly) to select a preset station number (1 to 8) 
while the MEMORY indicator is flashing.
• Rotate 

MPROGRAM rightward to select a higher preset 

station number.

• Rotate 

MPROGRAM leftward to select a lower preset 

station number.

Press J

MEMORY (or 0MEMORY) while the 

MEMORY indicator is flashing.
The station band and frequency appear in the front panel 
display with the preset station group and number you have 
selected. The MEMORY indicator disappears from the front 
panel display.

• Any stored station data existing under a preset station number is 

cleared when you store a new station under the same preset station 
number.

• The reception mode (stereo or monaural) is stored along with the 

station frequency.

You can exchange the assignments of two preset stations with each 
other. The example below describes the procedure to exchange 
preset station “E1” with “A5”.

Select preset station “E1” using M

PROGRAM on 

the front panel.
See “Selecting preset stations” on page 70.

Press and hold L

EDIT for more than 3 seconds.

The MEMORY indicator flashes in the front panel display.

Select preset station “A5” using M

PROGRAM.

The MEMORY indicator flash in the front panel display.
See “Selecting preset stations” on page 70.

Press L

EDIT again.

“E1–A5” appears in the front panel display and the 
assignments of the two preset stations are exchanged.

Before performing the following operations, set the operation mode 
selector on the remote control to FSOURCE and then press 
3TUNER.

A 1 : F M 8 8 . 9 M H z

A 1 : F M 8 8 . 9 M H z

A 1 : F M 8 8 . 9 M H z

E 1 : F M 8 8 . 9 M H z

E D I T

A 5 : F M 8 8 . 9 M H z

E D I T

A 5 : F M 8 8 . 9 M H z

E 1 - A 5