Zon legacy elite special4 Guida Utente

G U I T A R S

G U I T A R S

Midrange control. 12dB boost or cut of midrange at a frequency

selected by the mid sweep control. Turning the control clockwise boosts

the mids. Turning the control counterclockwise cuts the mids. The

detent, or “click,” in the center of the control is the “flat” position, zero

boost or cut.

Midrange sweep control. Provides a variable Q that is narrow in the low

frequencies and increasingly broad in the higher frequencies. Turning the

control from the fully counterclockwise position to the fully clockwise posi-

tion references (sweeps) frequencies from 200 Hz to 1,000 Hz. The

detent, or “click,” in the center of the knob’s rotation sets the sweep at

approximately 450 Hz. Rotate this control in either direction to sweep the

frequency band until you find the desired frequency to boost or cut.

Piezo (Icetone) control. Allows the blending of the signal from the piezo

elements (built into the individual monoliths) with the optical signal. Adding

Icetone enhances presence and brightness. Turning the control clockwise

increases the amount of piezo signal, while turning the control counter-

clockwise reduces the amount of piezo signal. Icetone cannot be selected

separately.

Power status LED. This red LED illumi-

nates when a 1/4" plug is inserted into the

output jack. This indicates the system is

powered on. The battery typically provides

15 hours of playing time on a single charge.

Note: Two hours of playing time remain

after this LED goes dark.

Power management LED. Located on the rear cover plate. Operates only

when charger is plugged in. Red indicates that the battery is charging.

Green indicates a full charge. A full charge is achieved in one hour.

Note: It is a normal function of this LED to show red each time the charger

is plugged in, even if the battery has just

been charged.

Charger jack. Insert the wall charger’s

output plug here to recharge the internal

NiMH battery or to use the AC power

adapter while playing.

Calibration instructions for S2 Lightwave

This system utilizes a beam of infrared light to sense string vibration, so

proper string/light-receptor alignment is necessary for optimum perform-

ance. Calibration of the system is typically required when new strings

are installed or when the playing action is modified.

Note: Adjust the string height (action) and set the intonation before cali-

brating the system.

1. Remove the rear cover plate and plug in a 1/4" cable to turn on the

Lightwave system. No amplifier connection should be made.

2. With a 2mm flat-blade screwdriver, carefully rotate the Motherboard’s

“CAL” rotary switch position from “0” to the first string to be adjusted.

The order does not matter.

1. Icetone treble-only or full-band

2. Icetone gain high/low

3. Daughterboard present/absent

4. Future option (no adjustment necessary)