Zhone 7995 Guida Utente
A. Configuration Options
7990-A2-GB20-20
September 2004
A-3
Max DSL Rate
Possible settings depend on whether Spectrum Management is enabled.
Determines the maximum speed for the DSL line when in Adaptive Rate mode (Max DSL
Rate does not equal Min DSL Rate). See
Rate does not equal Min DSL Rate). See
Table A-2, G.703 EIA-530 Payload Rates
, for
information about maximum payload rates for different DSL line rates.
Min DSL Rate
Possible settings depend on whether Spectrum Management is enabled.
Determines the minimum speed of the DSL line when in Adaptive Rate mode (Max DSL
Rate does not equal Min DSL Rate). See
Rate does not equal Min DSL Rate). See
Table A-2, G.703 EIA-530 Payload Rates
, for
information about maximum payload rates for different DSL line rates.
EIA-530 Payload Rate
Possible Settings: 64, 128 kbps
Default Setting: [Highest multiple of 64 kbps supported by the DSL Line Rate]
Default Setting: [Highest multiple of 64 kbps supported by the DSL Line Rate]
When the remote STU-R has an EIA-530-A interface, the Payload Rate set on the STU-C
determines the port speed of the synchronous port of the STU-R. Only 64 and 128 kbps
are selectable, otherwise this field is read-only. See
determines the port speed of the synchronous port of the STU-R. Only 64 and 128 kbps
are selectable, otherwise this field is read-only. See
Table A-2, G.703 EIA-530 Payload
Rates
, for information about maximum payload rates for different DSL line rates.
Remotely Initiated Loopback
Possible Settings: Enable, Disable
Default Setting: Enable
Default Setting: Enable
Specifies whether the unit will respond to a loopback command from the STU-R.
Remotely Initiated Loopback appears only when DSL Mode is set to STU-C.
Enable – The unit will respond to a loopback command issued from the STU-R.
Disable – The unit will not respond to a loopback command issued from the STU-R.
Peer IP Address
Possible Settings: 001.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Default Setting: 000.000.000.000
Specifies the peer IP address for the remote management link on the DSL loop.
Peer IP Address appears only when DSL Mode is set to STU-C (see
) and the system is IP Complex.
Address Field – (001.000.000.000 – 223.255.255.255) – Enter an address for the peer
unit. The range for the first byte is 001 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
unit. The range for the first byte is 001 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
Clear – Clears the IP address field and sets to all zeros.
Table A-1.
DSL Interface Options (2 of 3)