ZyXEL 2WG Guida Utente

 Chapter 44 Firmware and Configuration File Maintenance

ZyWALL 2WG User’s Guide

Figure 428   Telnet into Menu 24.5

1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your ZyWALL.  
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “bin” to set transfer mode to binary.
6 Use “get” to transfer files from the ZyWALL to the computer, for example, “get rom-0 

config.rom” transfers the configuration file on the ZyWALL to your computer and 
renames it “config.rom”. See earlier in this chapter for more information on filename 
conventions.

7 Enter “quit” to exit the ftp prompt. 

Figure 429   FTP Session Example

                      Menu 24.5 - Backup Configuration

To transfer the configuration file to your workstation, follow the 
procedure below:

   1. Launch the FTP client on your workstation.
   2. Type "open" and the IP address of your router. Then type 
      "root" and SMT password as requested.
   3. Locate the 'rom-0' file.
   4. Type 'get rom-0' to back up the current router  
      configuration to your workstation.

For details on FTP commands, please consult the documentation of your FTP 
client program.  For details on backup using TFTP (note that you must 
remain in this menu to back up using TFTP), please see your router manual.

Press ENTER to Exit:

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 
297.89Kbytes/sec.
ftp> quit