ZyXEL 2WG Guida Utente
Chapter 45 System Maintenance Menus 8 to 10
ZyWALL 2WG User’s Guide
658
45.1.1 Command Syntax
The command keywords are in courier new font.
Enter the command keywords exactly as shown, do not abbreviate.
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
Enter the command keywords exactly as shown, do not abbreviate.
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
45.1.2 Command Usage
A list of commands can be found by typing help or ? at the command prompt. Always type
the full command. Type exit to return to the SMT main menu when finished.
Figure 448 Valid Commands
The following table describes some commands in this screen.
Copyright (c) 1994 - 2007 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys ls exit ether
aux config wwan wlan
ip ipsec bridge bm
certificates cnm 8021x radius
radserv wcfg
ras>
ras> ?
Valid commands are:
sys ls exit ether
aux config wwan wlan
ip ipsec bridge bm
certificates cnm 8021x radius
radserv wcfg
ras>
Table 241 Valid Commands
COMMAND
DESCRIPTION
sys
The system commands display device information and configure device settings.
ls
The load sharing commands allow you to configure load balancing.
exit
This command returns you to the SMT main menu.
ether
These commands display Ethernet information and configure Ethernet settings.
poe
These commands deal with PPPoE connections.
pptp
These commands deal with PPTP connections.
aux
These commands display dial backup information and control dial backup connections.
config
These commands configure firewall and anti-spam settings.
ip
These commands display IP information and configure IP settings.
ipsec
These commands display IPSec information and configure IPSec settings.
bridge
These commands display bridge information.
bm
These commands configure bandwidth management settings and display bandwidth
management information.