ZyXEL 2WG Guida Utente

 Chapter 2 Introducing the Web Configurator

ZyWALL 2WG User’s Guide

The following table describes the labels in this screen.

Click the icon in the Show Statistics screen when the ZyWALL is set to router mode. This 
screen shows you a line chart of each port’s throughput statistics.

Figure 12   HOME > Show Statistics > Line Chart

Table 7   HOME > Show Statistics

Click the icon to display the chart of throughput statistics in router mode. 

Port

These are the ZyWALL’s interfaces.  

Status

For the WAN interface(s) and the Dial Backup port, this displays the port speed and 

duplex setting if you’re using Ethernet encapsulation or the remote node name for a 

PPP connection and Down (line is down or not connected), Idle (line (ppp) idle), 

Dial (starting to trigger a call) or Drop (dropping a call) if you’re using PPPoE 

encapsulation. Dial backup is not available in bridge mode.
For the LAN, DMZ and WLAN ports, this displays the port speed and duplex setting. 
For the WLAN card, this displays the transmission rate when WLAN is enabled or 

Down when WLAN is disabled.

TxPkts

This is the number of transmitted packets on this port.

RxPkts

This is the number of received packets on this port.

Collisions

This displays the number of collisions on this port in bridge mode.

Tx B/s

This displays the transmission speed in bytes per second on this port.

Rx B/s

This displays the reception speed in bytes per second on this port.

Up Time

This is the total amount of time the line has been up.

System Up Time This is the total time the ZyWALL has been on.

Automatic 

Refresh Interval 

Select a number of seconds or None from the drop-down list box to update all 

screen statistics automatically at the end of every time interval or to not update the 

screen statistics.

Refresh

Click this button to update the screen’s statistics immediately.