ZyXEL p-660h-61 Guida Utente
Prestige 660H Series User’s Guide
2-2
Introducing the Web Configurator
2.3.1 Using The Reset Button
1.
Make sure the PWR/SYS LED is on (not blinking).
2.
Press the RESET button for ten seconds or until the PWR/SYS LED begins to blink and then
release it. When the PWR/SYS LED begins to blink, the defaults have been restored and the
Prestige restarts.
Prestige restarts.
2.4 Navigating the Prestige Web Configurator
The following summarizes how to navigate the web configurator from the SITE MAP screen. We use
the Prestige 660H-61 web screens in this guide as an example. Screens vary slightly for different
Prestige models.
the Prestige 660H-61 web screens in this guide as an example. Screens vary slightly for different
Prestige models.
♦
Click Wizard Setup to begin a series of screens to configure your Prestige for the first time.
♦
Click a link under Advanced Setup to configure advanced Prestige features.
♦
Click a link under Maintenance to see Prestige performance statistics, upload firmware and
back up, restore or upload a configuration file.
back up, restore or upload a configuration file.
♦
Click Site Map to go to the Site Map screen.
♦
Click Logout in the navigation panel when you have finished a Prestige management session.
Figure 2-2 Web Configurator SITE MAP Screen
Click the
icon (located in the top right corner of most
screens) to view embedded help.
Table 2-1 Web Configurator Screens Summary
LINK SUB-LINK
FUNCTION
Wizard Setup
Use these screens for initial configuration including general setup, ISP
parameters for Internet Access and WAN IP/DNS Server/MAC address
assignment.
parameters for Internet Access and WAN IP/DNS Server/MAC address
assignment.
Advanced Setup
Wizard Setup
Navigation panel
Logout