ZyXEL ES-3148 Guida Utente

Chapter 19 Policy Rule

ES-3148 User’s Guide

To view a summary of the classifier configuration, scroll down to the summary table at the 
bottom of the Policy screen. To change the settings of a rule, click a number in the Index field.

Figure 76   Advanced Application > Policy Rule: Summary Table 

The following table describes the labels in this screen. 

Outgoing

Select Send the packet to the mirror port to send the packet to the mirror port. 
Select Send the packet to the egress port to send the packet to the egress port. 
Select Send the matching frames (broadcast or DLF, multicast, marked for 

dropping or to be sent to the CPU) to the egress port to send the broadcast, 

multicast, DLF, marked-to-drop or CPU frames to the egress port. 
Select Set the packet’s VLAN ID to set the VLAN ID of the packet with the value you 

configure in the VLAN ID field. 

Metering

Select Enable to activate bandwidth limitation on the traffic flow(s) then set the 

actions to be taken on out-of-profile packets. 

Out-of-profile 

action

Select the action(s) to be performed for out-of-profile traffic. 
Select Drop the packet to discard the out-of-profile traffic. 
Select Change the DSCP value to replace the DSCP field with the value specified in 

the Out of profile DSCP field. 
Select Set Out-Drop Precedence to mark out-of-profile traffic and drop it when 

network is congested.
Select Do not drop the matching frame previously marked for dropping to 

queue the frames that are marked to be dropped.

Add

Click Add to inset the entry to the summary table below and save your changes to 

the Switch’s run-time memory. The Switch loses these changes if it is turned off or 

loses power, so use the Save link on the top navigation panel to save your changes 

to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Clear

Click Clear to set the above fields back to the factory defaults.

Table 49   Advanced Application > Policy Rule (continued)

Table 50   Policy: Summary Table 

Index

This field displays the policy index number. Click an index number to edit the policy. 

Active

This field displays Yes when policy is activated and No when is it deactivated.

Name

This field displays the name you have assigned to this policy. 

Classifier(s) This field displays the name(s) of the classifier to which this policy applies.   

Delete

Click Delete to remove the selected entry from the summary table.

Cancel

Click Cancel to clear the Delete check boxes.