ZyXEL ES-3148 Guida Utente

Chapter 29 Maintenance

ES-3148 User’s Guide

Follow the steps below to reset the Switch back to the factory defaults. 

1 In the Maintenance screen, click the Click Here button next to Load Factory Default 

to clear all Switch configuration information you configured and return to the factory 
defaults. 

2  Click OK to reset all Switch configurations to the factory defaults.

Figure 133   Load Factory Default: Start 

3 In the web configurator, click the Save button to make the changes take effect. If you 

want to access the Switch web configurator again, you may need to change the IP 
address of your computer to be in the same subnet as that of the default Switch IP 
address (192.168.1.1).

Click Config 1 to save the current configuration settings permanently to Configuration 1 on 
the Switch. 
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration 
changes to the current configuration. 

"

Clicking the Apply or Add button does NOT save the changes permanently. 
All unsaved changes are erased after you reboot the Switch. 

Save 

Configuration

Click Config 1 to save the current configuration settings to Configuration 1 on the 

Switch. 
Click Config 2 to save the current configuration settings to Configuration 2 on the 

Switch. 

Reboot 

System

Click Config 1 to reboot the system and load Configuration 1 on the Switch. 
Click Config 2 to reboot the system and load Configuration 2 on the Switch. 

Note: Make sure to click the Save button in any screen to save your 

settings to the current configuration on the Switch.

Table 93   Management > Maintenance  (continued)