ZyXEL P-2602HW Manuale Utente

 Chapter 9 Wireless LAN

P-2602H(W)(L)-DxA User’s Guide

The following table describes the labels in this screen.

Before you click Start, you should enable OTIST on all the OTIST-enabled devices in the 
wireless network. For most devices, follow these steps.

1 Start the ZyXEL utility
2 Click the Adapter tab.
3 Select the OTIST check box, and enter the same Setup Key as the ZyXEL Device.
4 Click Save.

Figure 69   Example: Wireless Client OTIST Screen

To start OTIST in the device, click Start in this screen.

"

You must click Start in the ZyXEL Device and in the wireless device(s) within 
three minutes of each other. You can start OTIST in the wireless devices and 
the ZyXEL Device in any order.

After you click Start in the ZyXEL Device, the following screen appears (in the ZyXEL 
Device).

Table 39   Network > Wireless LAN > OTIST

Setup Key

Type a key (password) 8 ASCII characters long. 

Note: If you change the OTIST setup key in the ZyXEL Device, 

you must change it on the wireless devices too.

Yes!

Select this if you want the ZyXEL Device to automatically generate a pre-

shared key for the wireless network. Before you do this, click Network > 

Wireless LAN > General and set the Security Mode to No Security.
Clear this if you want the ZyXEL Device to use a pre-shared key that you 

enter. Before you do this, click Network > Wireless LAN > General, set the 

Security Mode to WPA-PSK, and enter the Pre-Shared Key.

Start

Click Start to activate OTIST and transfer settings. The process takes three 

minutes to complete.

Note: You must click Start in the ZyXEL Device and in the 

wireless device(s) within three minutes of each other. 
You can start OTIST in the wireless devices and the 
ZyXEL Device in any order.