ZyXEL P-2602HW Guida Utente

Chapter 8 LAN Setup

P-2602H(W)(L)-DxA User’s Guide

Click Network > DHCP Setup to open this screen. Use this screen to configure the DNS 
server information that the ZyXEL Device sends to the DHCP client devices on the LAN.

Figure 57   DHCP Setup

The following table describes the labels in this screen.

Allow between 

LAN and WAN

Select this check box to forward NetBIOS packets from the LAN to the WAN and 

from the WAN to the LAN. If your firewall is enabled with the default policy set to 

block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall 

rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN 

and from the WAN to the LAN.

Back

Click Back to return to the previous screen.

Apply

Click Apply to save the changes. 

Cancel

Click Cancel to begin configuring this screen afresh.

Table 27   Advanced LAN Setup (continued)

Table 28   DHCP Setup 

DHCP Setup

DHCP

If set to Server, your ZyXEL Device can assign IP addresses, an IP default 

gateway and DNS servers to Windows 95, Windows NT and other systems that 

support the DHCP client.
If set to None, the DHCP server will be disabled. 
If set to Relay, the ZyXEL Device acts as a surrogate DHCP server and relays 

DHCP requests and responses between the remote server and the clients. 

Enter the IP address of the actual, remote DHCP server in the Remote DHCP 

Server field in this case. 
When DHCP is used, the following items need to be set: