ZyXEL p-660hwp Manuale Utente

Appendix F Command Interpreter

P-660HWP-Dx User’s Guide

This section provides some general examples of how to use the log commands. The items that 
display with your device may vary but the basic function should be the same. 
Go to the command interpreter interface. 

1 Use the sys logs load command to load the log setting buffer that allows you to configure 

which logs the P-660HWP-Dx is to record. 

2 Use sys logs category to view a list of the log categories.

Figure 212   Displaying Log Categories Example

3 Use sys logs category followed by a log category to display the parameters that are 

available for the category.

Figure 213   Displaying Log Parameters Example

4 Use sys logs category followed by a log category and a parameter to decide what to 

record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to 
record only alerts for that category, and 3 to record both logs and alerts for that category. 
Not every parameter is available with every category.

5 Use the sys logs save command to store the settings in the P-660HWP-Dx (you must do 

this in order to record logs).

• Use the sys logs display command to show all of the logs in the P-660HWP-Dx’s log.
• Use the sys logs category display command to show the log settings for all of the log 

categories.

Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys             exit            ether           aux
ip              ipsec           bridge          bm
certificates    cnm             8021x           radius
ras>

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/1:show debug 
type]