ZyXEL 793H Guida Utente
Chapter 24 LAN Setup
P-793H User’s Guide
260
Figure 150 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
24.4.1 Port-based VLAN Setup
You use menu 3.6 to control whether or not the ZyXEL Device sends layer-2 traffic (MAC
addresses) between LAN ports. For example, if LAN port 1 and LAN port 2 are connected to
different departments, you might not want the ZyXEL Device to broadcast traffic to both
networks. In this case, you should disable the connection between these ports. These
departments then have to communicate with each other using IP addresses, instead of MAC
addresses.
From the main menu, enter 3 to open Menu 3 - LAN Setup and select sub-menu 6.
addresses) between LAN ports. For example, if LAN port 1 and LAN port 2 are connected to
different departments, you might not want the ZyXEL Device to broadcast traffic to both
networks. In this case, you should disable the connection between these ports. These
departments then have to communicate with each other using IP addresses, instead of MAC
addresses.
From the main menu, enter 3 to open Menu 3 - LAN Setup and select sub-menu 6.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Table 100 Menu 3.2.1: IP Alias Setup
FIELD
DESCRIPTION
IP Alias 1, 2
Choose Yes to configure the LAN network for the ZyXEL Device.
IP Address
Enter the IP address of your ZyXEL Device in dotted decimal notation.
IP Subnet Mask
Your ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1, RIP-2B or RIP-2M.
Incoming
protocol filters
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyXEL Device.
Outgoing
protocol filters
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyXEL Device.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.