ZyXEL 793H Guida Utente

Chapter 2 Introducing the Web Configurator

P-793H User’s Guide

This is the same screen discussed in 

If you forget your password or cannot access the web configurator, you will need to use the 
RESET button at the back of the ZyXEL Device to reload the factory-default configuration 
file. This means that you will lose all configurations that you had previously and the password 
will be reset to “1234”.

1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and 

then release it. When the POWER LED begins to blink, the defaults have been restored 
and the ZyXEL Device restarts.

Rx B/s

This field displays the number of bytes received in the last second.

Up Time 

This field displays the elapsed time this port has been up. 

LAN Port Statistics

Interface

This field displays the type of port.

Status 

This field displays Down (line is down), Up (line is up or connected) if you're 

using Ethernet encapsulation and Down (line is down), Up (line is up or 

connected), Idle (line (ppp) idle), Dial (starting to trigger a call) and Drop 

(dropping a call) if you're using PPPoE encapsulation.

TxPkts 

This field displays the number of packets transmitted on this port.

RxPkts 

This field displays the number of packets received on this port.

Collisions

This is the number of collisions on this port.

Help

Click this to open the embedded help.

Poll Interval(s)

Type the time interval for the browser to refresh system statistics.

Set Interval

Click this button to apply the new poll interval you entered in the Poll Interval 

field above.

Stop

Click this button to halt the refreshing of the system statistics.

Table 4   Status > Packet Statistics (continued)