Sharp AR-M162 Guida Utente

Pagina di 160
22
BEFORE USING THE PRODUCT
DISABLING (ENABLING) AUTO TRAY SWITCHING
When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper 
from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate 
when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you 
prefer to disable the function, follow the steps below.
1
Press the [SPECIAL FUNCTION] key.
The special function 
screen will appear.
The above screen appears in copy mode.
2
Select "PAPER SIZE SET" with the [
or [
] key.
3
Press the [OK] key.
The paper size setting 
screen will appear.
4
Press the [
] key repeatedly until 
"AUTO TRAY SWITCHING" appears.
Move the cursor to the lowest tray and then press the 
[
] key again. The above screen will appear.
5
Press the [OK] key.
When a checkmark does not appear in the checkbox, 
the auto tray switching function will not operate.
6
Press the [
] key.
You will return to the 
paper size setting screen.
To re-enable auto tray switching, press the [OK] key in 
the screen of step 5 so that a checkmark appears.
DUPLEX
SPECIAL FUNCTION
ACC. 
DUPLEX SCAN
DUPLEX SCAN
 SPECIAL FUNCTION
  
SPECIAL MODES
  ORIG. SIZE ENTER
  PAPER SIZE SET
  DISPLAY CONTRAST
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
 SPECIAL FUNCTION
  SPECIAL MODES
  ORIG. SIZE ENTER
  
PAPER SIZE SET
  DISPLAY CONTRAST
GHI
OK
BACK
 PAPER SIZE SET
   
8 x11R
    11x17
   11x17     8 x14
             8 x13
             8 x11
1
2
1
2
1
2
1
2
 PAPER SIZE SET
   
AUTO TRAY
   
SWITCHING
OK
 PAPER SIZE SET
   
AUTO TRAY
   
SWITCHING
 PAPER SIZE SET
   
8 x11R
    11x17
   11x17     8 x14
             8 x13
             8 x11
1
2
1
2
1
2
1
2
Pegasus-E_Copy_Sec.book  22 ページ  2006年2月15日 水曜日 午後1時33分