Maytag mcb2256he Guida Utente

3. Close doors.

4. Remove top hinge covers by

removing Phillips screws.

5. Unscrew

⁄

" hex head screws from

top hinges.

For ice and water
dispensing models only:

• Do not remove screw

connecting green ground
wire.

6. For ice and water

dispensing models only: Detach main wire
connector harness and red wire harness.

• To detach main wire

harness, use a flat blade
tool or fingernail to press
junction point between two
connectors to release.

• To detach red wire harness,

press tab on underside of
connector to release.

7. Remove top hinges along with

doors.

Installation

• If tube end is damaged, cut off

⁄

" before

reconnecting.

• If leaking occurs, reconnect the line.

8. Remove bottom hinges with a

⁄

" hex head driver.

Replacing the Doors

• To replace the doors, follow the steps in Door and

Hinge Removal in reverse order.

IMPORTANT: If water line tube end is damaged, cut
off

⁄

" before reconnecting.

Connecting the Water Supply

(select models)

To reduce the risk of injury or death, follow
basic precautions, including the following:

• Read all instructions before installing ice maker.
• Do not attempt installation if instructions are not

understood or if they are beyond personal skill
level.

• Observe all local codes and ordinances.
• Do not service ice maker unless specifically

recommended in Use & Care Guide or published
user-repair instructions.

• Disconnect power to refrigerator before installing

ice maker.

• Water damage due to an improper water

connection may cause mold/mildew growth. Clean
up spills or leakage immediately!

WARNING

To avoid property damage or possible injury,
follow basic precautions, including the
following:

• Consult a plumber to connect

⁄

" O.D. copper

tubing to household plumbing to assure
compliance with local codes and ordinances.

• Confirm water pressure to water valve is between

35 and 100 pounds per square inch, 20 pounds
per square inch without filter.

• Do not use a self-piercing, or

⁄

" saddle valve.

Both reduce water flow can become clogged over
time, and may cause leaks if repair is attempted.

• Tighten nuts by hand to prevent cross threading.

Finish tightening nuts with pliers and wrenches.
Do not overtighten.

• Wait two to three hours before placing refrigerator

into final position to check and correct any water
leaks. Recheck for leaks after 24 hours.

• Verify the copper tubing under the sleeve is

smooth and free from defects. Do not reuse an old
sleeve.

CAUTION