Brother HL-8050N Manuale Utente
5 - 15 TROUBLESHOOTING
What to Do When an Error Message Appears
LCD messages
Error Messages
Standard paper tray
TRAY 1 and TRAY 2
Optional paper tray
TRAY 3 and TRAY 4
Optional duplex unit for Duplex printing
DX
Offset catch tray
CT
Message
Meaning and Action
NO TONER
Install the toner cartridge correctly.
See Replacing the Toner Cartridge (TN-1700) on page 6-1.
See Replacing the Toner Cartridge (TN-1700) on page 6-1.
ILLEGAL TONER
Use only a Brother genuine toner cartridge.
NO PAPER XXX
Put paper in the empty tray.
NO TRAY XXX
Put the paper tray in the printer.
COVER OPEN
Close the top cover of the printer.
Close the back cover of the printer.
Ensure that the cover of the DX is closed.
Close the CT cover of the printer.
Close the back cover of the printer.
Ensure that the cover of the DX is closed.
Close the CT cover of the printer.
BACK LEVER ERROR
Lower the Back lever.
JAM XXX
Carefully pull out the jammed paper from the indicated area. See Clearing Paper Jams
on page 5-17.
on page 5-17.
STACKER FULL
Take some paper out of the output tray.
SIZE MISMATCH
Put the same size paper in the paper tray that is selected in the printer driver, and then
press the Go button.
press the Go button.
MEDIATYPE ERROR
Specify the correct type of media.
MANUAL FEED
Put the same size of paper in the paper tray as is shown on the LCD. If the printer is
'paused', press the Go button.
'paused', press the Go button.
SIZE ERROR TX
Put the same size paper in the paper tray that is selected in the printer driver. See
Suitable and Unsuitable Paper Types on page 2-1.
Suitable and Unsuitable Paper Types on page 2-1.
SIZE ERROR DX
You can only print in the sizes specified for Duplex printing. Check printer driver setting
and paper size in the tray. See Suitable and Unsuitable Paper Types on page 2-1.
and paper size in the tray. See Suitable and Unsuitable Paper Types on page 2-1.
SIZE ERROR CT
The CT does not accept the paper size specified. Select the corrected paper size in the
printer driver. See Suitable and Unsuitable Paper Types on page 2-1.
printer driver. See Suitable and Unsuitable Paper Types on page 2-1.
LT-8000 FAIL
Optional Lower Tray is removed. Turn off the printer, and then turn it on again.
DX-8000 FAIL
Optional Duplex unit is removed. Turn off the printer, and then turn it on again.
CT-8000 FAIL
Optional Offset Catch Tray is removed. Turn off the printer, and then turn it on again.
DIMM ERROR
Re-install the DIMM correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. If this error message
appears again, replace the DIMM with a new one.
Turn off the printer. Wait a few seconds, and then turn it on again. If this error message
appears again, replace the DIMM with a new one.
CARD ERROR
Make sure of the following:
■
The CompactFlash card is installed properly.
■
The installed CompactFlash card is formatted properly.
Turn off the printer. Wait a few seconds, then turn it on again. If this error message
appears again, replace the CompactFlash card with a new one.
appears again, replace the CompactFlash card with a new one.