Runco rs-1100 Guida Utente
RS-900 and RS1100 Series Installation/Operation Manual
63
PRE
L
IMINAR
Y
Select Information from the Main Menu to see projector status information: the
currently-active source, input signal resolution, aspect ratio, picture memory and lamp
usage. This menu also displays the projector serial number.
currently-active source, input signal resolution, aspect ratio, picture memory and lamp
usage. This menu also displays the projector serial number.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
answer your questions or resolve product performance issues.
To access advanced projector settings, use the up- or down-arrow keys to highlight
Setup and press ENTER. Use the number buttons on the remote to enter the Setup
menu passcode when prompted and press ENTER again. Then, press MENU on the
remote control.
Setup and press ENTER. Use the number buttons on the remote to enter the Setup
menu passcode when prompted and press ENTER again. Then, press MENU on the
remote control.
Lamp Power: Select Lamp Power from the Setup Menu to adjust the lamp output level.
You can choose to run the lamp as bright as possible (200W; this is the default setting) or
you can choose the lower (170W) setting. Generally, lower lamp output prolongs the life of
the lamp, but decreases brightness.
You can choose to run the lamp as bright as possible (200W; this is the default setting) or
you can choose the lower (170W) setting. Generally, lower lamp output prolongs the life of
the lamp, but decreases brightness.
Lamp Hours: When you replace the projector lamp (refer to Lamp Replacement on
page 69), you should also reset the lamp timer. To do this, select Lamp Hours from the
Setup menu. Press the right-arrow key on the remote to highlight “Yes,” then press
ENTER to confirm the reset.
page 69), you should also reset the lamp timer. To do this, select Lamp Hours from the
Setup menu. Press the right-arrow key on the remote to highlight “Yes,” then press
ENTER to confirm the reset.
Fan Mode: Select Fan Mode from the Setup Menu to control the operation of the
projector’s cooling fan.
projector’s cooling fan.
In most cases, the default Fan Mode (Normal) will maintain the correct operating
temperature. If the lamp frequently turns off due to overheating, or in certain high-altitude
operating environments, you may need to change this setting to Hi. Altitude or Manual.
temperature. If the lamp frequently turns off due to overheating, or in certain high-altitude
operating environments, you may need to change this setting to Hi. Altitude or Manual.
To manually set the fan speed, select Manual and press ENTER. Then, use the on-screen
slidebar to adjust the speed.
slidebar to adjust the speed.
Background Color: Press the
or
button to select the image Background Color
(black, blue or gray). The Background Color appears when no incoming signal is present.
PIP: To enable or disable the picture-in-picture (PIP) feature, highlight PIP in the Setup
menu and press
menu and press
or
to select On or Off.
HDMI 1
1920x1080
16:9
ISF Night
450
RUP900RS0805001
You can also press INFO on the RS-900/RS1100 remote control unit
(Figure 2-4) to display this information.
(Figure 2-4) to display this information.
Tip
200 Watts
>
Normal
Black
Off
0
Normal
0
>
0
You only need to enter the Setup menu passcode the first time you
select that menu after turning on the projector.
select that menu after turning on the projector.
Reset the Lamp Timer ONLY after you replace the lamp. Otherwise,
the reported “Lamp Hours” will be inaccurate.
the reported “Lamp Hours” will be inaccurate.
Do not exceed the recommended lamp life of 2000 hours. An old
lamp becomes increasingly fragile and prone to sudden failure.
lamp becomes increasingly fragile and prone to sudden failure.
Note
Note
WARNING