Garmin 200 Istruzione Sull'Installazione

Pagina di 6
 
GMX 200 STC Installation 
005-C0315-00 Rev A 
STC Master Data List 
Page 3 of 6 
 
1. INTRODUCTION 
1.1 Purpose 
The purpose of this document is to list the data required to support STC installation of the Garmin 
GMX 200 Multi-Function Display in accordance with STC requirements, and to list other data associated 
with the STC which is not required for installation. 
1.2 Scope 
This document applies to the installation of the GMX 200 units when installed IAW the data listed in this 
document on the Approved Model List aircraft as defined for this STC. This document includes general 
installation requirements, special installation instructions, and it provides an index of STC data including 
both data required for installation and data associated with the STC, but not required for installation. 
1.3 Document 
Revision 
This document shall be released, archived, and controlled in accordance with Garmin document control 
system.  As such when this and other documents are revised, the entire document is revised and the 
new revision nomenclature is changed on each page of the revised document.       
1.4 Definitions 
The following terminology is used within this document: 
1)  AC:  Advisory Circular 
2)  AML: Approved Model List 
3)  DER:  Designated Engineering Representative 
4)  FAA:  Federal Aviation Administration 
5)  FARs:  Federal Aviation Regulations 
6)  IAW:  In accordance with 
7)  STC:  Supplemental Type Certificate 
8)  TIA:  Type Inspection Authorization 
2.  DATA AND EQUIPMENT LIST REQUIRED FOR INSTALLATION 
2.1 Data 
Required 
for Installation 
2.1.1  GMX 200 Installation Data  
All documents listed in Table 1 are required for installation purposes for new installations of the 
GMX 200 equipment. All documents must be of the revision listed or later FAA approved revisions.