Garmin 340c Manuale Proprietario

I

NSTALLING

 

THE

 F

ISHFINDER

 340C > 

M

OUNTING

 

THE

 T

RANSDUCER

Proper transducer installation is key to getting the best performance 

from your new Fishfinder. If the transducer lead is too short, 

extension cables are available from your Garmin dealer. Coil and 

secure any excess cable. DO NOT cut the transducer lead or any 

part of the transducer cable, because this voids your warranty. The 

cable cannot be spliced and connected to any existing (Garmin or 

non-Garmin) transducer cables.
Following are some tips and basic installation instructions for some 

popular transducers. Detailed installation instructions are provided 

in the transducer kits. Some transducers might have to be installed 

by a professional marine installer.

1.   Insert the rubber washer and plastic spacer into the 

transducer at the same time. DO NOT lubricate the rubber 

washer.

2.  Route the cable toward the back of the transducer. Slide the 

transducer into the transducer mount.

3.   Place a 5 mm flat washer on the 10-32 x 1.75" screw, and 

insert the screw through the transducer mount, spacer, and 

rubber washer.

4.   Place the remaining 5 mm flat washer on the exposed 

end. Install the 10-32 lock nut tight. You can tighten the 

transducer further after installation on the boat.