Garmin 305 Guida All'Installazione Rapida

3.  Place the heart rate monitor directly on your skin, just below the 

breastplate. Wrap the strap around your chest and attach the 

strap to the other side of the heart rate monitor.

4.  Adjust the strap so it stays in place during your ride.
5.  When positioned correctly, verify that your Edge is receiving 

data. The heart rate icon changes from flashing to constant 

. If not, go to 

 > 

 > 

 > 

 to activate your heart rate monitor or restart scan. 

For more information about the heart rate monitor, refer to the 

owner’s manual.

The Edge 305 with heart rate includes a wireless heart rate monitor 

that you wear directly on your skin, just below the breastplate. 

1.  Push one tab on the strap through the slot in the heart rate 

monitor. Press the tab down.

sensors

2.  Wet both sensors on the back of the heart rate monitor to 

create a strong connection between your pulse and the 

transmitter.

The Edge 305 with cadence includes a wireless speed and cadence 

sensor. Both magnets must be aligned with their respective indication 

line and be within 5 mm of the GSC10 for the Edge to receive data.

1.  Place the GSC10 on the rear chain stay (the side opposite of 

the drive train). Loosely attach the GSC10 using two cable ties.

2.  Attach the pedal magnet to the crank arm using the adhesive 

mount and a cable tie. Make sure the indication line on the 

pedal magnet lines up with the indication line on the GSC10.

3.  Unscrew and attach the spoke magnet. Make sure it is aligned 

with the sensor arm indication line. 

4.  Unscrew and move the GSC10 sensor arm to within 5 mm of 

the spoke magnet. 

5.  Press the 

 button on the GSC10. The LED turns red, then 

green. Pedal to test the sensor alignment. The red LED blinks 

each time the crank arm passes the sensor, and the green LED 

blinks each time the wheel magnet passes the sensor arm.

6.  When everything is aligned and working correctly, tighten 

the cable ties, sensor arm, and spoke magnet. For more 

information about the GSC10, see the owner’s manual.

1.  Press 

 to access the 

 

. 

2.  Select 

 > 

.

3.  Specify your 

, 

, and 

 using the 

 

 and the 

button.

1.  Press 

 to access the 

 

. 

2.  Select 

 > 

.

3.  Specify your 

 profile 

(configure up to three bikes) and 

. 

4.  If you are using a GSC10, select 

. Then you can 

specify 

 and 

. 

May 2006 

190-00580-01 Rev. D 

Printed in Taiwan

Use the Garmin Training Center software on your personal 

computer to plan your advanced workouts and courses before 

you ride and analyze them afterwards. Install Garmin Training 

Center from the installation disk in the product box. For help 

using Garmin Training Center, click the Help menu in the 

software or press 

 on your keyboard.

reset button 

cable ties

indication 

line

cable tie

indication 

line

sensor arm 

indication 

line

spoke 

magnet

pedal 

magnet

Quick Reference Guide

Edge

™

 205/305