Garmin 530 Guida Utente
6
TAKEOFF TOUR
The Instrument Panel Self-Test Page includes selections to set fuel on board (FOB) to full capacity and
access the Checklists Page. This allows you to quickly set fuel to full limits and display any check lists you’ve
entered, such as start up or takeoff checklists.
entered, such as start up or takeoff checklists.
To set fuel on board to full (if not provided by sensor):
1. Rotate the large right knob to highlight “Set Full Fuel?”.
2. Press ENT and verify that fuel on board (FOB) now matches the fuel capacity (CAP) fi gure. Fuel on board is
now reduced, over time, based on the fuel fl ow (FF) fi gure.
To view the checklists page:
1. Rotate the large right knob to highlight “Go To Checklists?” and press ENT.
2. Rotate the large right knob to select the desired checklist, then follow the steps on page 140 to execute
each step in the selected checklist.
3. Once you complete the desired checklist(s), press the small right knob to return to the Checklists Page. Press
the small right knob again to return to normal operation on the Satellite Status or Map pages.
Once you’ve verifi ed instrument operation with the Instrument Panel Self-Test Page dis-
played, rotate the large right knob to highlight “OK?” and press the ENT key.
played, rotate the large right knob to highlight “OK?” and press the ENT key.
The Satellite Status Page appears as the GNS 530 begins to collect satellite information. An ‘Acquiring’
status is displayed on the Satellite Status Page and the signal strength of any satellites received appears as “bar
graph” readings. This is a good indication that you are receiving signals and that a position fi x is determined.
Following the fi rst-time use of your GNS 530, the time required for a position fi x varies — usually from one
to two minutes.
graph” readings. This is a good indication that you are receiving signals and that a position fi x is determined.
Following the fi rst-time use of your GNS 530, the time required for a position fi x varies — usually from one
to two minutes.
If the unit can only obtain enough satellites for 2D navigation (no altitude), the unit uses the altitude
provided by your altitude encoder (if one is connected).
Select “Set Full Fuel?” to set fuel on board (FOB) to
full capacity.
full capacity.
Select “Go To Checklists?” to display the Checklist
Page and any available checklists. The GNS 530
can hold up to nine checklists with up to 30 entries
in each checklist.
Page and any available checklists. The GNS 530
can hold up to nine checklists with up to 30 entries
in each checklist.
Fuel On Board and Checklists
i-60.indd 6
4/11/2003, 8:55:44 AM