Garmin 530w Guida Utente
8 - VLOC RECEIVER
157
Auto-tuning
To select a VLOC frequency from the Waypoint
VOR or Nearest VOR Pages:
VOR or Nearest VOR Pages:
1. Select the desired page from the main pages.
(See the page references on the preceding
page.)
page.)
2. Press the small right knob momentarily to
activate the flashing cursor.
3. Turn the large right knob to highlight the
frequency for the desired VOR.
4. Press ENT to place the frequency in the standby
field of the VLOC window.
5. Press the VLOC flip-flop key to activate the
selected frequency.
6. Press the small right knob to remove the
flashing cursor.
NOTE: For duplex COM operations, the VLOC re-
ceiver may be auto-tuned from the Nearest Flight
Service Station Page.
ceiver may be auto-tuned from the Nearest Flight
Service Station Page.
When selecting a VOR or ILS approach, manual
tuning of the VLOC receiver is not required. Once the
approach procedure is “Loaded” or “Activated”, the
GNS 530W automatically places the proper frequency
in the standby field of the VLOC window. If you wish
to use this frequency, simply press the VLOC flip-flop
key to activate the frequency. Additional information
on approach procedures is provided in Section 5.
approach procedure is “Loaded” or “Activated”, the
GNS 530W automatically places the proper frequency
in the standby field of the VLOC window. If you wish
to use this frequency, simply press the VLOC flip-flop
key to activate the frequency. Additional information
on approach procedures is provided in Section 5.
To select an approach and automatically tune the
proper VLOC frequency:
proper VLOC frequency:
1. Select the destination airport using the direct-
to key or as the last waypoint in the active
flight plan.
flight plan.
2. Press the PROC key to display the Procedures
Page.
3. Turn the large right knob to highlight “Select
Approach?” and press ENT.
4. A window appears listing the available proce-
dures. Turn the small right knob to highlight
the desired procedure and press ENT.
the desired procedure and press ENT.
5. A second window appears listing available transi-
tions. Turn the small right knob to highlight the
desired transition waypoint and press ENT (the
approach “Vectors” option assumes that you will
receive vectors to the final course segment of the
approach and thus provides navigation guidance
to intercept this final course).
desired transition waypoint and press ENT (the
approach “Vectors” option assumes that you will
receive vectors to the final course segment of the
approach and thus provides navigation guidance
to intercept this final course).
6. Turn the large right knob to highlight “Load?”
or “Activate?” and press ENT. (“Load?” adds
the procedure to the flight plan without imme-
diately using it for navigation guidance. This
allows you to continue navigating the original
flight plan, but keeps the procedure available
on the Active Flight Plan Page for quick activa-
tion when needed.)
the procedure to the flight plan without imme-
diately using it for navigation guidance. This
allows you to continue navigating the original
flight plan, but keeps the procedure available
on the Active Flight Plan Page for quick activa-
tion when needed.)
GNS 530W only