Garmin 188 sounder Istruzione Sull'Installazione

© Copyright 2005 Garmin Ltd. or its subsidiaries

Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas  66062, U.S.A.

www.garmin.com

Part Number  190-00264-00  Rev. D      February 2005  Printed in Taiwan

(1/8")

3.0 mm

(5.58")

141.6 mm

(4.33")

110.0 mm

TRIM TEMPLATE ALONG THIS LINE TO AID FITTING 

CUT MOUNTING SURFACE 
ALONG INSIDE OF THIS LINE

UNIT OUTLINE

DRILL A 3/8" HOLE.   
BEGIN CUTTING HERE.

Be very careful when cutting this hole, 
there is only a small amount of clearance
between the unit and the Mounting Holes.

Drill four 3mm (1/8") mounting holes at the indicated locations. 
Install the four Mounting Studs into unit by screwing the shorter section in to 
the back of the unit. 
Use a 1/16” (2mm) Allen Wrench to tighten the Mounting Studs until the stop 
contacts the case. Be careful not to overtighten as this may damage the 
Mounting Stud! The studs have a reusable thread-locking patch pre-applied from 
the factory. 
Place the unit in position in the cut out in the mounting surface.
Place washers over the Mounting Studs, then thread on one Hex Nut per 
Mounting Stud. 
Tighten all four until the unit is snug against the mounting surface. 
Install and tighten the second Hex Nut on all four Mounting Studs to lock 
the first one in place.