Garmin 292 Guida Utente
GPSMAP 292/298 Owner’s Manual
101
A
PPENDIX
>
M
ESSAGES
Messages
Accuracy Alarm—the GPS accuracy has fallen outside of user-set
value.
Alarm Clock—the alarm clock has sounded.
Anchor Drag Alarm—you have drifted out of the specified
Alarm Clock—the alarm clock has sounded.
Anchor Drag Alarm—you have drifted out of the specified
distance range.
Antenna Input is Shorted—some part of the antenna wiring is
Antenna Input is Shorted—some part of the antenna wiring is
contacting the chassis.
Approaching [Waypoint Name]—you are a specified alarm
Approaching [Waypoint Name]—you are a specified alarm
distance from a destination waypoint.
Arriving At [Waypoint Name]—you arrived at the destination
Arriving At [Waypoint Name]—you arrived at the destination
waypoint.
Battery Alarm—battery voltage has fallen below the value entered
Battery Alarm—battery voltage has fallen below the value entered
in the Battery Alarm setup.
Can’t Read User Card—error reading card; remove and reinsert.
Can’t Read User Card—error reading card; remove and reinsert.
Contact your dealer or Garmin Product Support if the problem
persists.
Can’t Read Voltages That High, Limited To Top Of Range—the
Can’t Read Voltages That High, Limited To Top Of Range—the
voltage value in the Battery Alarm setup is higher than the unit can
read.
Can’t Read Voltages That Low, Limited To Bottom Of Range—
Can’t Read Voltages That Low, Limited To Bottom Of Range—
voltage value in the Battery Alarm setup is lower than the voltage
where the unit automatically turns off.
Can’t Unlock Maps—data on data card is not unlocked for the
unit. Contact your dealer or Garmin Product Support.
Can’t Write User Card, Data Card May Be Full—error reading
Can’t Write User Card, Data Card May Be Full—error reading
card; remove and reinsert. Contact your dealer or Garmin Product
Support if the problem persists.
Can’t Write User Card, Data Card Is Read-Only—the data card
Can’t Write User Card, Data Card Is Read-Only—the data card
in your unit contains data copy protection.
Database Error—internal problem with the unit. Contact your
Database Error—internal problem with the unit. Contact your
dealer or Garmin Product Support to have the unit serviced.
Deep Water Alarm—the water is deeper than the amount set in the
Deep Water Alarm—the water is deeper than the amount set in the
Deep Water Alarm.
Directory Item With This MMSI Already Exists—MMSI
Directory Item With This MMSI Already Exists—MMSI
number already in DSC directory. Use a different number.
Directory Memory is Full, Can’t Create Entry—DSC directory
Directory Memory is Full, Can’t Create Entry—DSC directory
has reached maximum of 100 contacts. Delete unneeded contacts to
add new ones.
Distress Call—a DSC distress call has been received. Take
Distress Call—a DSC distress call has been received. Take
appropriate action.
Drift Alarm—the depth has changed by the amount of the Drift
Drift Alarm—the depth has changed by the amount of the Drift
Alarm value.
Fish Alarm (not a textual alarm, is indicated by a fish bitmap
Fish Alarm (not a textual alarm, is indicated by a fish bitmap
flashing in the upper left part of the display)—shows an icon
and a beep sounds (if enabled) when a fish is detected. This alarm
does not show a message banner.