Garmin 17 Istruzione Sull'Installazione

I

NSTALLATION

 I

NSTRUCTIONS

 

•  Flush Mount Template
•  Jig saw
•  Masking tape
•  Scissors
•  Drill 
•  Drill Bits—1/8" (3 mm) and 3/8" (6 mm)
•  1/16" (2 mm) Allen (hex) wrench
•  Sockets
•  Hammer
•  Center punch
To flush mount the GPSMAP 3005C:

1.  Trim the Flush Mount Template for fit, and tape it in the preferred location.
2.  Using a center punch, indent the center of each mounting hole location.
3.  Using an 1/8" (3 mm) drill bit, drill the four mounting holes. 
4.  Using a 3/8" (6 mm) drill bit, drill a hole for a location and begin cutting the mounting surface.
5.  Using the jig saw, cut the mounting surface along the inside of the line indicated on the template. Be very careful when cutting this hole, 

because there is 1/8" clearance between the case molding and the mounting holes.

6.  Install the four mounting studs into unit by screwing the shorter, threaded section into the back of the unit. Use a 1/16" (2 mm) Allen 

Wrench to tighten the mounting studs until the stop contacts the case.  

Be careful not to overtighten as this may damage the mounting stud! 

The studs have a reusable thread-locking patch pre-applied from the 

factory.

7.  Place the unit into the cut-out of the mounting surface.
8.  Place washers over the mounting studs, then thread on one hex nut per 

mounting stud. Tighten all four until the unit is snug against the mounting 

surface. Install and tighten the second hex nut set on all four mounting 

studs to lock the first set in place.

Stud

Washer

Hex Nuts

Mounting Surface

���������

���������

Drill a 3/8" 

(6 mm)

 hole

to start cut.

Be very careful when cutting. There is 1/8” 

clearance between the case and the 

mounting stud holes. If the cutout is tight, file

or sand the cutout to obtain the correct fit.

1. Trim the Flush Mount Template for fit and tape in the desired location.
2. Using a Center Punch, indent the center of each Mounting Hole location.
3. Drill the four Mounting Holes using a 1/8" (3 mm) drill bit. 
4. Drill a 3/8" (6 mm) hole for a location to begin cutting the mounting surface.
5. Cut along the inside of the indicated line. Be very careful when cutting this hole, 

    there is 1/8" clearance between the case molding and the Mounting Holes.
6. Install the four Mounting Studs into the unit by screwing the shorter, threaded section 

    into the back of the unit. Use a 1/16" (2 mm) Allen Wrench to tighten the Mounting Studs

    until the stops contact the case. Do not to overtighten the studs. The studs have a factory

    applied thread locking patch. 
7. Position the GPSMAP 3005C in the cut out of the mounting surface.
8. Place washers over the Mounting Studs, then thread on one Hex Nut per Mounting Stud. 

    Tighten all four until the unit is snug against the mounting surface.

    Install and tighten the second Hex Nut on all four Mounting Studs to lock the first one 

    in place.