Garmin 3005c Manuale Proprietario

G

ETTING

 S

TARTED

 > 

T

URNING

 

ON

 

THE

 GPSMAP 3005C

Before you turn on the GPSMAP 3005C, make sure the unit and GPS 17 antenna 

are correctly installed on your vessel according to the instructions in the  

GPSMAP 3005C & GPS 17 Installation Instructions.
The first time you turn on the GPSMAP 3005C, the GPS 17 receiver must collect 

satellite data and determine its current location. To ensure proper initialization, 

the GPSMAP 3005C is shipped from the factory in AutoLocate mode.

1.  Press and hold the 

POWER key until the unit turns on.

2.  When 

I Agree is highlighted on the Warning Page, press ENTER to open 

the Map Page.

  Press and hold the 

POWER key until the unit turns off.

You can adjust the screen backlighting on the GPSMAP 3005C from any page by 

using the POWER/BACKLIGHT key.

1.  Press and release the 

POWER/BACKLIGHT key. 

2.  Press up on the 

ROCKER to increase the brightness, or press down to 

decrease.

  TIP: After you open the Backlight adjustment window, press the  

POWER/BACKLIGHT key repeatedly to cycle through the three  

backlight settings: Highest, Middle, and Lowest.

3.  Press 

ENTER or QUIT to close the Backlight adjustment window.