Garmin 3005c Manuale Proprietario

A

PPENDIX

 > 

I

NSTALLING

 

AND

 R

EMOVING

 D

ATA

 C

ARD

The GPSMAP 3005C uses optional Garmin BlueChart and MapSource data 

cards. By updating your GPSMAP 3005C software to version 3.0 or later, you can 

use optional preprogrammed BlueChart g2 data cards.
Insert the data card in the card slot located on the front left of the unit. Data cards 

can be installed or removed at any time, whether the unit is on or off.

1.  Open the data card door by sliding the door in the direction of the arrow, 

and lift the door open from left to right.

2.  Insert the card into the slot, with the label facing the right screen and the 

handle facing toward you.

3.  Push the card into the unit. It in not necessary to force the card and 

about 1/2" is still exposed when it is properly inserted. If the unit is on, a 

confirmation tone sounds, and a message appears on-screen noting the 

card details when the card is properly installed and accepted.

4.  Close the cover until it locks.

If you insert a data card and get a card format not recognized message, remove 

the card and reinsert it. If the card is still not recognized, contact Garmin Product 

Support or your Garmin dealer for assistance. Data cards are not waterproof, 

should not be exposed to moisture or excessive static charges, and should be 

stored in the case supplied with the card.
The first time you insert a data card, the unit takes a few seconds to read the 

card. After the data card is read, a summary page appears. Press 

ENTER to 

acknowledge.

Slide the data card door in 

the direction of the arrow (to 

the left) and pull to open it.

Data Card slot

1.  Open the data card door by sliding the door in the direction of the arrow, 

and lift the door open from left to right.

2.  Grasp the card handle and pull out firmly.
3.  If the unit is on, a confirmation tone sounds when the data card is 

removed.