Garmin 536 Guida Utente
GPSMAP 400/500 Series Owner’s Manual
Getting Started
To turn on Simulator mode:
1. From the Home screen, select
Configure
>
System
>
Simulator
.
2. Select
Setup
to set speed, track control, and position.
Viewing System Information
You can view the software version, the basemap version,
supplemental map information (if applicable), the unit ID number
for your chartplotter, and your XM
®
WX Satellite Weather
®
Radio
ID (if available). You may need this information to update the
system software or to purchase additional map data information.
From the home screen, select
From the home screen, select
Configure
>
System
>
System
information
.
restoring the Original Factory Settings
NOTE: This procedure deletes all settings information you have
entered.
1. From the Home screen, select
Configure
>
System
>
System
Information
>
Factory Settings
.
2. Select
Yes
to restore all factory settings, or select
no
to cancel.
The unit reboots and prompts you to adjust unit settings (
).
Inserting and removing SD Cards
Your unit supports Secure Digital (SD) cards. Insert optional
BlueChart
®
g2 Vision
®
SD cards to view high-resolution satellite
imagery and aerial reference photos of ports, harbors, marinas
and other points of interest. Use SD cards to transfer data such as
waypoints, routes, and tracks to another compatible Garmin unit or
. The SD card slot is located on the lower-right
corner of the unit.
To insert the SD card, open the access door and press the SD card in
To insert the SD card, open the access door and press the SD card in
until it clicks. Press the card in again and release it to eject it from
the chartplotter.