Garmin 60cs Manuale Proprietario

IMPORTANT NOTE: 

When the USB cable is con-

nected to the GPS map 60CS, 

it is automatically detected and 

communicates only in Garmin 

Format. When the USB is con-

nected, Garmin format will not 

communicate through the Serial 

connection, while all other 
formats can be used by the 

Serial connection with the USB 

still connected.  

RTCM In - Provides DGPS input using a standard RTCM SC-104  

  format. No output.

RTCM In/NMEA Out - Allows DGPS input using a standard RTCM  

  SC-104 format and supports the output of standard NMEA  
  0183 version 3.01 data.

RTCM In/Text Out - Allows DGPS input using a standard RTCM  

  SC-104 format and supports the output of simple ASCII text output of  
  location and velocity information

None - Provides no interfacing capabilities.

1.  Access the Interface Setup Page as explained at the beginning 

of this section.

2.  Highlight the desired setting and press ENTER.
3. When you select Text Out and /or RTCM In, additional fields will 

appear. Use the ROCKER key to highlight “Baud Rate” and 

press ENTER. Use the ROCKER key to highlight the desired 

setting and press ENTER.

4. For Garmin DGPS or RTCM In/NMEA Out, use the ROCKER key 

to highlight “Beacon” and press ENTER. Use the ROCKER key 

to select “Scan” or “User” and press ENTER. 

  If “Scan” is selected, the GPSmap 60CS will automatically direct 

the beacon receiver to scan for available beacon transmitters.

   If “User” is selected,  then select the “Freq” and “Bit Rate” fields 

and enter the appropriate settings. The beacon status, signal-to-noise 

ratio and distance to beacon are displayed in the bottom of the page. 

 

 

 

Data Format Page for 

GARMIN DGPS

Data Format Page for: 

NMEA In/NMEA Out

Text Out
RTCM In

RTCM In/Text Out

Data Format Page for 

RTCM In/NMEA Out