Garmin 11 Manuale Proprietario
GTM 11 Owner’s Manual
3
T
ESTING
AND
M
OUNTING
THE
GTM 11
T
ESTING
THE
GTM 11
Use the following testing and troubleshooting techniques:
Observe the LED on the GTM 11: Service reception is indicated by the
Observe the LED on the GTM 11: Service reception is indicated by the
green solid light, which can take up to five minutes to appear for initial
data acquisition.
Yellow dot-dash flashes: determining which country
you are currently in.
Yellow solid light: searching table for active entry or
scanning for new TMC FM stations
Red solid light: momentary sync loss.
Green solid light: normal traffic data.
Check the Map: Check the map on the GPS device for traffic incidents.
Refer to the owner’s manual to learn how to access the map page.
Verify Signal Strength: The traffic information list on the GPS device
Verify Signal Strength: The traffic information list on the GPS device
shows a signal strength indicator in the upper-right corner. Verify that the
bars are solid green. Refer to the owner’s manual to learn how to access
the information list.
Verify that you are in a service area: Check for service from the pay
Verify that you are in a service area: Check for service from the pay
service or free services, if available. To view service areas, go to the
Garmin Web site at http://www.garmin.com/fmtraffic.
Verify that the paid subscription is activated: If the GTM 11 is using a
Verify that the paid subscription is activated: If the GTM 11 is using a
pay service, verify that the subscription has been activated in the Garmin
GPS device. Refer to the GPS device’s owner’s manual
to learn how to
add subscriptions to the GPS device.
M
OUNTING
THE
GTM 11
After you have connected and tested the GTM 11, you can mount it using
the hook-and-loop fastener or the permanent adhesive. For best signal
reception, mount the GTM 11 on the A-pillar, which is the area between
the windscreen and the door. If possible, mount the GTM 11 so you can
see the LED.
To mount the GTM 11 with the permanent adhesive:
To mount the GTM 11 with the permanent adhesive:
1. Clean and dry a section of the A-pillar or other suitable
mounting surface.
2. Remove the backing from the adhesive. Firmly press the
adhesive on the back of the GTM 11.
Attach the adhesive here.
3. Position so the antenna is pointing up.
4. Remove the backing from the adhesive.
5. Firmly press the GTM 11 to the mounting surface.
4. Remove the backing from the adhesive.
5. Firmly press the GTM 11 to the mounting surface.
NOTE: When mounted, the adhesive is extremely difficult to remove.