Garmin 2620 Manuale Proprietario

64

Attaching the Vehicle Adapter to the StreetPilot 2620/2660

Your vehicle adapter is a 12/24 volt DC adapter with an external speaker system. This adapter is your 

StreetPilot’s power source when you are in a vehicle (the StreetPilot does not use batteries).  Use the AC 
adapter (included) when using the StreetPilot indoors. 

1.   Locate the power connector on the rear of the StreetPilot. The connector is “keyed” with a notch located 

towards the bottom of the plug.

2.   Mate the power plug on the vehicle adapter to this connector by aligning the notches and sliding the plug 

into the connector until fully seated, as shown below.

3.   Plug the cigarette lighter portion of the vehicle adapter into an available cigarette lighter receptacle in 

your vehicle. Use care when routing the adapter cable to ensure that it does not interfere with vehicle 
operation in any way.

The vehicle adapter comes with an external speaker 
system that enables you to hear directions from your 
StreetPilot.

Periodically, you may need to change the fuse 
that’s located at the tip of the vehicle adapter. 
Simply unscrew the black, round end piece and 
remove/replace the fuse. 

A 3AGC/3AG 1 amp 
fuse is located at 
the tip of the vehicle 
adapter

Attach the vehicle adapter to the back of your 
StreetPilot as shown above.