Garmin 2820 Guida All'Installazione Rapida

➌

1.  Flip the power switch down to turn on your 2820. 
2.  Follow the screen prompts to configure the 2820; you only have to do this once.

➍

1.  Press the 

MENU key. 

2.  Touch 

 > 

 > 

 

. 

3.  If you have never paired a device with your 2820, touch 

. If you have already paired a device with your 2820 and want 

to add another, touch 

. 

4.  Set your phone to “Find Me,” “Discoverable,” or “Visible” mode. Touch 

 on the 2820. 

5.  Touch your device in the list. 
6.  If your phone model appears in the list, touch it. If not, touch 

.

7.  When pairing your phone, enter the 2820’s PIN code (1234) 

into your phone when prompted. 

8.  From the Main menu, touch 

. Use the Mobile Phone 

menu to place calls and review your call history. 

 You must have the external microphone connected or a 

headset with Bluetooth wireless technology paired to your 2820 in order to place a call.

➋

  Touch 

.

➌

  Touch 

 and 

.

➊

  Touch 

➍

  Touch a category.

➏

  Touch 

.

➎

  Touch a place.

Follow the route to your destination using the map. As you travel, your 

2820 guides you to your destination with voice prompts, arrows, and 

directions along the top of the map. If you depart from the original 

route, your 2820 recalculates the route and provides new route 

instructions.

 For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the 2820 installed to place and secure the device so it does 

not interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an 

accident.

To use the mounting base with adhesive disks, start with 

➊

. To use the non-skid friction mount, start with 

➋

.

➊

 

1.  Clean and dry the area where you want to place the mounting 

base. 

2.  Remove the liner from the bottom of the base. 
3.  With the locking lever facing you, position the base on the cleaned 

area. Apply pressure to adhere the base to the dashboard. 

➋

1.  Align the power plug on the vehicle adapter to the connector and 

slide the plug until fully seated.

2.  Slide the locking lever on the base to the left (unlocked).
3.  Slide the bottom of the 2820 into the base until it clicks into place. 
4.  Slide the locking lever to the right (locked). 
5.  Plug the power cable into a 12-Volt receptacle in your vehicle. 
6.  Route the cable so it does not interfere with vehicle operation.

© Copyright 2006 Garmin Ltd. or its subsidiaries

May 2006 

190-00633-01 Rev. B 

Printed in Taiwan

Your route is marked with a magenta line.

Follow the arrows.

A checkered 

flag marks your 

destination.

StreetPilot

 2820

Indicates your 

cellular phone’s 

battery level and 

signal strength

Power 

plug

Locking lever

Release tab

Mounting 

base

Power 

switch