Garmin c320 Guida All'Installazione
Step 1: Configure Your c320
Press and hold the
Power button to turn
on the unit.
Note: A “Low Battery”
warning may appear when
you turn on the unit. Charge
the unit for three hours.
1
2
Answer the configuration questions that appear. When you
see the screen that states “To use this unit, map data must be
installed,” you are ready to install software and map data.
Start Here
Open this setup guide and follow the instructions to set up your c320.
Complete all of the setup steps:
Complete all of the setup steps:
Step 1: Configure your c320
Step 2: Install software and map data
Step 3: Load maps
Step 2: Install software and map data
Step 3: Load maps
Do not connect the USB cable to your PC until you are instructed to do so.
StreetPilot
®
c320
This setup guide includes instructions to
configure your c320 and load maps.
configure your c320 and load maps.
To ensure a successful installation, follow
the steps outlined in this guide.
the steps outlined in this guide.
Do not
connect the USB cable to your PC until you
are instructed to do so.
are instructed to do so.
For information about using your c320, refer
to the
to the
c320 Quick Reference Guide
located in
the box. Also see the
c320 Owner’s Manual
at www.garmin.com/products/sp320/.
se
tup guid
e
190-00435-02 Rev. C
Volume control
Power button
USB cable connector