Garmin c510 Manuale Proprietario

A

PPENDIX

Use the enclosed mounting disk to 

mount your unit to the dashboard and to 

comply with certain state regulations. 
Important: The permanent mounting 

adhesive is extremely difficult to remove 

after it is installed. 
To install the mounting disk:

1.  Clean and dry the dashboard where 

you are placing the disk.

2.  Remove the backing from the 

permanent mounting adhesive on the 

bottom of the disk.

3.  Place the disk on the dashboard.
4.  Place the suction cup mount on top of 

the disk. Flip the lever down (toward 

the disk).

If your unit locks up (freezes up), press 

and hold the   

 button to turn off 

the unit. Then turn the unit back on. If 

this does not help, reset your c510. 
To reset the c510:

1.  Place your thumb nail in the groove 

located under the Garmin logo on the 

faceplate. 

2.  Gently pull off 

the faceplate. 

3.  Press the 

 button. 

4.  Connect the 

c510 to a 

power source using the power cable. 

The c510 should automatically turn 

back on and operate normally.

 

NOTE: If you need to reset your unit 

often, update the system software. 

 for information about 

updating the software.