Planar LC12 Guida Specifiche
Title: Engineering Specification: 12.1-inch AMLCD Monitor
Page 16 of 27
Document Number: 023-0284-00
Revision: A
5.0
DC POWER INPUT REQUIREMENTS
5.1 DC Power Input Lines
The DC Power Input Connector consists of two (2) positions wired numerically and supplied attached
to the Monitor as a chassis mounted connector per definitions listed in.
to the Monitor as a chassis mounted connector per definitions listed in.
PIN NUMBER
SIGNAL NAME
1
Most Positive Input Voltage
2
Most Negative Input Voltage
Figure 10. DC Power Input Connector- Pin Assignments
The DC Power Input Connector is a 2 pin MAT-N-LOK type with male pin contacts
AMP 1 480699
.
Pin number assignments are defined in Figure 11; shown below is the physical layout as seen by the
interface cable from the DC power source.
interface cable from the DC power source.
Figure 8. DC Power Input Connector Illustration
5.2 DC Input Voltage / Current
DC Input Voltage: 12 vdc nominal, + 0.4 vdc.
Over the specified input voltage range:
-
No loss of image synchronization occurs.
-
White display luminance level is within 10% of luminance at nominal input voltage.
-
DC Input Current: 4.3 amp maximum current draw (12.4-vdc applied) steady state
conditions.
conditions.
Refer to Figure 12 for required current profile characteristics at “power–up” conditions.
The Monitor is not damaged by input voltages ranging from 0-vdc to 12.4-vdc".