Planar LC12 Guida Specifiche
Title: Engineering Specification: 12.1-inch AMLCD Monitor
Page 8 of 27
Document Number: 023-0284-00
Revision: A
•
Power spectrum is referenced per MIL STD 810 E Environmental Test Method 505.3, Table -II
Spectral Energy Distribution and permitted tolerances
Spectral Energy Distribution and permitted tolerances
•
Maximum solar power flux = 1120 watts/m
2
at 65 degrees normal to the Monitor surface.
•
These values assume no solar radiation attenuation from the customer-supplied vandal shield.
3.3 Altitude
Maximum operating altitude is 3,000 meters [9,850 feet]. Maximum shipping and storage altitude is
12,000 meters [39,400 feet].
12,000 meters [39,400 feet].
3.4 Mechanical Vibration and Shock
Note: Tests performed with unpackaged Monitors are mounted in a Planar approved rigid retaining
fixture.
fixture.
3.4.1 Vibration
Non-Operating (sinusoidal):
10-200 Hz, 0.9g acceleration, 120 seconds per sweep
for 15 minutes, three axes, (x, y, z).
for 15 minutes, three axes, (x, y, z).
Following exposure unit shall meet all performance
requirements.
requirements.
Non-operating (random):
10-200 Hz, 0.02g
2
/Hz, 10 min/axis, three (x, y, z).
Following exposure unit shall meet all performance
requirements.
requirements.
3.4.2 Shock
Note: Tests performed with unpackaged Monitors are mounted in a Planar approved rigid
retaining fixture.
retaining fixture.
Non-operating:
30 g, > 2.5 ms duration, ½ sine, 1 shocks per axis.
Following exposure unit shall meet all performance
requirements.
Following exposure unit shall meet all performance
requirements.
3.4.3 Shock Packaged Product
Non-operating:
30 inch free fall or simulated drop, 1 drop per side, 6
sides and 1 drop per edge, 3 edges 1 shocks per axis.
With accelerometer attached to center of product
display screen, a maximum of 50 G’s is allowed.
Following exposure unit shall meet all performance
requirements
sides and 1 drop per edge, 3 edges 1 shocks per axis.
With accelerometer attached to center of product
display screen, a maximum of 50 G’s is allowed.
Following exposure unit shall meet all performance
requirements
.
Y (rear)
X (side)
Z (bottom)
DISPLAY