Kodak I4200 Guida Utente

A-61651 December 2009

5-11

This section provides procedures for replacing the following parts. Use the list 
below as a guideline for frequency of replacement.

•

Feed module tires and separation roller tires — tire life will vary 

depending upon paper types, environment and cleanliness. Nominal tire 
life is approximately 600,000 documents; results will vary. Degradation of 
feeder performance, multiple feeds, stoppages, etc. indicate a need to 
change tires. Change all the tires on the feed module and separation roller 
at the same time.

•

Feed module and separation roller — it is recommended that you install 

a new feed module and separation roller every 4th tire change. Install a 
new feed module and separation roller at the same time.

•

Pre-separation pad — it is recommended that you change the pre-

separation pad at least as often as you change the feed module/separation 
roller tires.

•

Imaging guides — replace when the imaging guides are heavily 

scratched and defects show in the image.

1. Remove the output tray.

2. Lift up and open the printer access cover. 

NOTE: If you do not want to remove the output tray, you can lift the front of the 

output tray, then lift the printer access cover and position the printer 
access cover behind the height adjustment tab.