Kodak I4200 Guida Utente

5-16

A-61651 December 2009 

The imaging guides should be replaced when they are heavily scratched and 
defects show in the image.

NOTE: Handle the imaging guides carefully so as to not put fingerprints on the 

guides.

1. Open the scanner cover.

2. Loosen the screws on each end of the lower imaging guide and remove it 

from its position.

3. Install the new imaging guide and tighten the screws to secure the imaging 

guide.

4. Repeat Steps 2 and 3 to replace the upper imaging guide.

5. Close the scanner cover.

In the rare case that you may need to replace the Flippable White Background 
strip(s), follow the procedures below.

1. Open the scanner cover.

2. Loosen the two screws on each end of the lower background strip and 

remove it from its position.

3. Disconnect the background strip connector.

4. Connect the new background strip connector with the cable. Be sure it is 

securely in place.

5. Install the new background strip and tighten both screws on each side 

to secure the background strip.

6. Repeat Steps 2 - 5 to replace the upper background strip.

7. Close the scanner cover.