Kodak I4200 Guida Utente
A-61651 December 2009
6-3
Indicator lights and
error codes
error codes
Steady green: the scanner is scanning.
Fast flashing green: waiting for operator action.
Slow flashing green: the scanner is in power saver mode.
Steady red: indicates a scanner error, such as the scanner cover is open.
Steady red then flashing green — scanner is powering up.
After you power up the scanner, the red and green indicator lights flash. After
approximately 12 seconds, both lights go out. When the green indicator light
comes back on and the function window displays “1”, the scanner is ready to
begin scanning. However, the host computer may require several seconds to
detect the scanner.
approximately 12 seconds, both lights go out. When the green indicator light
comes back on and the function window displays “1”, the scanner is ready to
begin scanning. However, the host computer may require several seconds to
detect the scanner.
Falling bar — when the scanner is waiting for an operator action, a blue bar
will step down in succession from top to bottom in the function window.
will step down in succession from top to bottom in the function window.
Problem
Possible Solution
Roller marks or streaks appear on
documents after scanning
documents after scanning
Clean the feed module, separation roller and tires. Refer to Chapter 5,
Maintenance.
Maintenance.
Vertical lines appear on the image
• Clean the imaging guides. Refer to Chapter 5, Maintenance.
• Enable the Streak Filter option or increase the aggressiveness.
Documents are multifeeding
Make sure that:
• the leading edges of all batched documents are centered in the feeder
so that each document will come in contact with the feed rollers.
• the feed module and separation roller are clean and not worn.
• documents with an unusual texture or surface are fed manually.
• the gap release toggle switch is not pushed in.
U3 is displayed in the function window
The document(s) you are trying to scan is too long.
• Verify that the Document Management: Maximum Length option on
the Device-General tab (TWAIN Datasource) or the Longest
Document option on the Scanner tab (ISIS Driver) is set to longer than
the longest document being scanned. The default is 43.2 cm (17
inches).
Document option on the Scanner tab (ISIS Driver) is set to longer than
the longest document being scanned. The default is 43.2 cm (17
inches).
• Decrease the resolution.