Avery Dennison 9416 xl Guida Specifiche
C o n n e c t i n g t h e C o m m u n i c a t i o n C a b l e
Before the printer can accept print jobs from the host, you must
♦
connect the communication cable to the printer and the host.
♦
set the communication values on the printer to match those at the host (only
required if you are using the serial port).
required if you are using the serial port).
For parallel communication:
1. Turn off the printer before connecting the cable.
2. Connect a parallel printer cable from the computer to the parallel port at the back
of the printer.
Parallel Port
3. Secure the cable with the spring clips.
For serial communication:
1. Turn off the printer before connecting the cable.
2. Connect a serial printer cable
from the host to the serial port
at the back of the printer.
at the back of the printer.
9-pin
Serial Port
Serial Port
USB Port
3. Secure the cable with the
connecting screws.
The factory defaults are
9600 Baud, 8-bit data frame,
1 stop bit, no parity, and
DTR flow control.
9600 Baud, 8-bit data frame,
1 stop bit, no parity, and
DTR flow control.
To set communication
values, refer to the Packet
Reference Manual.
values, refer to the Packet
Reference Manual.
Getting Started 1-3