JVC gr-d650 Manuale Istruttivo

MasterPage: Start_Right

During recording, a time code is recorded on the 
tape. This code is to confirm the location of the 
recorded scene on the tape during playback. 

* Frames are not displayed during recording.

If recording starts from a blank portion, the time 
code begins counting from “00:00:00” 
(minute:second:frame). If recording starts from 
the end of a previously recorded scene, the time 
code continues from the last time code number. 
If during recording a blank portion is left partway 
through the tape, the time code is interrupted. 
When recording is resumed, the time code 
starts counting up again from “00:00:00”. This 
means the camcorder may record the same time 
codes as those existing in a previously recorded 
scene. To prevent this, perform Recording From 
The Middle Of A Tape (

 pg. 21) in the following 

cases;

●

When shooting again after playing back a 
recorded tape.

●

When power shuts off during shooting. 

●

When a tape is removed and re-inserted during 
shooting.

●

When shooting using a partially recorded tape. 

●

When shooting on a blank portion located partway 
through the tape.

●

When shooting again after shooting a scene then 
opening/closing the cassette holder cover.

●

The time code cannot be reset.

●

During fast-forwarding and rewinding, the time 
code indication does not move smoothly.

●

The time code is displayed only when “TIME 
CODE” is set to “ON”. (

Enables to check the end of the last recording.
1) Press QUICK REVIEW during the Recording-
Standby mode.
2) Tape is rewound for about several seconds 
and played back automatically, then pauses in 
the Recording-Standby mode for the next shot.

●

Distortion may occur at start of playback. This is 
normal.

1) Play back a tape or use Blank Search 
(

 pg. 22) to find the spot at which you want to 

start recording, then engage the Still Playback 
mode. (

2) Set the Power Switch to “REC” while pressing 
down the Lock Button located on the switch, 
then start recording.

GR-D650US.book  Page 21  Monday, February 27, 2006  9:38 AM