GoVideo vr2940 Manuale Del Prodotto

Pagina di 48
5
1
Alternate Warnings - This product is 
equipped with a three-wire grounding-type 
plug, a plug having a third (grounding) pin. 
This plug will only fit into the outlet, contact 
your electrician to replace your obsolete 
outlet. Do not defeat the safety purpose of 
the grounding-type plug.
1
Power-Cord Protection - Power-supply 
cords should be routed so that they are 
not likely to be walked on or pinched by 
items placed upon or against them, paying 
particular attention to cords at plugs, 
convenience receptacles, and the point 
where they exit from the product.
1
Outdoor Antenna Grounding - If an 
outside antenna or cable system is 
connected to the product, be sure the 
antenna or cable system is grounded so 
as to provide some protection against 
voltage surges and built-up static charges. 
Section 810 of the National Electrical Code, 
ANSI/NFPA 70 provides information with 
regard to proper grounding of the mast 
and supporting structure, grounding of the 
lead-in wire to an antenna discharge unit, 
size of grounding conductors, location 
of antenna-discharge unit, connection to 
grounding electrodes, and requirements for 
the grounding electrode.
1
Lightning - For added protection for this 
product during a lightning storm or when 
it is left unattended and unused for long 
periods of time, unplug it from the wall 
outlet and disconnect the antenna or cable 
system. This will prevent damage to the 
product due to lightning and power-line 
surges.
1
Power Lines - An outside antenna system 
should not be located in the vicinity of 
overhead power lines or other electric light 
or power circuits, or where it can fall into 
such power lines or circuits. When installing 
an outside antenna system, extreme care 
should be taken to keep from touching such 
power lines or circuits as contact with them 
might be fatal.
Important Safety Instructions (cont.)
1
Overloading - Do not overload wall outlets, 
extension cords, or integral convenience 
receptacles as this can result in a risk of 
fire or electric shock.
1
Object and Liquid Entry - Never push 
objects of any kind into this product through 
openings as they may touch dangerous 
voltage points or short-out parts that could 
result in a fire or electric shock. Never spill 
liquid of any kind on the product.
2
Servicing - Do not attempt to service this 
product yourself as opening or removing 
covers may expose you to dangerous 
voltage or other hazards. Refer all servicing 
to qualified service personnel.
2
Damage Requiring Service - Unplug 
this product from the wall outlet and refer 
servicing to qualified service personnel 
under the following conditions:
a  When the power-supply cord or plug is 
damaged.
b  If liquid has been spilled or objects have 
fallen into the product.
c  If the product has been exposed to rain 
or water.
d  If the product does not operate normally 
by following the operating instructions. 
Adjust only those controls that are 
covered by the operating instructions 
as an improper adjustment of other 
controls may result in damage and 
will often require extensive work by 
a qualified technician to restore the 
product to its normal operation.
e  If the product has been dropped or 
damaged in any way.
f   When the product exhibits a distinct 
change in performance-this indicates a 
need for service.
2
Replacement Parts - When replacement 
parts are required, be sure the service 
technician has used replacement parts 
specified by the manufacturer or that have 
the same characteristics as the original 
part. Unauthorized substitutions may result 
in fire, electric shock, or other hazards.
23 
Safety Check - Upon completion of any 
service or repairs to this product, ask the 
service technician to perform safety checks 
to determine that the product is in proper 
operating condition.
24 
Heat - The product should be situated 
away from heat sources such as radiators, 
heat registers, stoves, or other products 
(including amplifiers) that produce heat.
25 
Wall or Ceiling Mounting - The product 
should be mounted to a wall or ceiling only 
as recommended by the manufacturer.