Calculated Industries Construction Master Pro Guida Utente

(Cont’d)

Note: You may set your calculator to display the Jack Rafter
lengths in either ascending or descending order (see Preference
Settings on page 83).

Note: You may set your calculator to “mate up” with the Jack
Rafters, rather than using the entered or default On-center 
spacing for both sides (see Preference Settings on page 83).

ß 5

— Used to store a

value 

other than the default of 16 Inches On-center

(e.g., 

1 8 i ß 5

stores an 18-inch On-center)

for Jack Rafter calculations. Press 

® 5

to review

the stored value.

Ç j

— Operates same

as 

j

, but displays the rafter values from the

Irregular

pitched side first.

Ç r

— This function finds the stud

sizes in a 

Rake-Wall

based on calculated or entered

values for pitch, rise and/or run. Repeated presses
of 

r

will display the various sizes. The sizes can

be displayed in either descending (from longest to
shortest) or ascending (from shortest to the longest)
order, depending upon your preference setting (see
Preference Settings on page 83). If a dimensional
value is entered before pressing 

Ç r

, this value

will be taken as the Rake-Wall base size and auto-
matically added to the various rafter lengths.

ß 5

— Used to store a

value 

other than the default of 16 Inches On-center

(e.g., 

1 8 i ß 5

stores an 18-inch On-center)

for Rake-Wall stud calculations. Press 

® 5

to

review the stored value.