Canon MX850 Manuale Utente
98
Faxing
Using Useful Receiving Functions
Memory Receiving
If the machine receives a fax under one of the following conditions, the machine will not be able
to print the received fax and will store it in its memory. When the problem is resolved as
described, the fax stored in memory is printed automatically.
z
to print the received fax and will store it in its memory. When the problem is resolved as
described, the fax stored in memory is printed automatically.
z
Ink has run out while receiving a fax: replace the ink tank.
z
Paper has run out while receiving a fax: load the paper and press the OK button.
z
Paper other than A4, Letter, or Legal-sized paper is loaded: Load A4, Letter, or Legal-sized
paper, then press the OK button.
paper, then press the OK button.
z
OFF is selected for Auto print received: select ON, and print the faxes stored in memory
from the Memory reference screen. Refer to “Auto print received” in “Device Settings” of the
User’s Guide on-screen manual.
from the Memory reference screen. Refer to “Auto print received” in “Device Settings” of the
User’s Guide on-screen manual.
z
You pressed the Stop/Reset button to cancel printing of a fax: press the FAX button.
Remote Receiving
If the machine is located away from the telephone, pick up the handset of the telephone
connecting to the machine and dial 25 (the remote reception ID) to receive faxes (remote
reception).
z
connecting to the machine and dial 25 (the remote reception ID) to receive faxes (remote
reception).
z
If you use a rotary pulse line, temporarily switch your telephone to tone dialing. For details on
how to switch to tone dialing, refer to the instruction manual supplied with your telephone.
how to switch to tone dialing, refer to the instruction manual supplied with your telephone.
z
If you have an answering machine connected to the machine that can carry out remote
control operations, the security code for this function may be the same as the remote
reception ID. In this case, change the remote reception ID in Remote RX ID in Remote RX in
RX settings under FAX settings. Refer to “Remote RX” in “Device Settings” of the User’s
Guide on-screen manual.
control operations, the security code for this function may be the same as the remote
reception ID. In this case, change the remote reception ID in Remote RX ID in Remote RX in
RX settings under FAX settings. Refer to “Remote RX” in “Device Settings” of the User’s
Guide on-screen manual.
Remote reception can be disabled. Refer to “Remote RX” in “Device Settings” of the User’s
Guide on-screen manual.
Guide on-screen manual.
Note
You can set to print received faxes forcibly even if an ink has run out.
However, a part of contents or all contents of the fax may not be printed since the ink has run out.
However, a part of contents or all contents of the fax may not be printed since the ink has run out.
And also, the contents of fax will not be stored in memory.
In addition, if ink has already run out, it is recommended that OFF be selected for Auto print
In addition, if ink has already run out, it is recommended that OFF be selected for Auto print
received in RX settings to store the received fax in memory once and print the fax manually after
replacing the ink tank.
Refer to “Auto print received” in “Device Settings” of the User’s Guide on-screen manual.
Refer to “Auto print received” in “Device Settings” of the User’s Guide on-screen manual.
Important
z
The machine can store up to approximately 250 pages (approximately 30 documents)* of faxes
in memory.
z
If the memory becomes full, the machine cannot receive any more faxes. Print or delete the
originals stored in memory, and make the sender resend the faxes. See “Document Stored in
Memory” on page 99.
* When using ITU-T No.1 chart (Standard mode)
* When using ITU-T No.1 chart (Standard mode)