Haier ab142acbac Manuale Utente
14
FOR COMFORTABLE USE
43
15
/ 26
-7 / -8
24 / 18
C
C
C
C
C
C
C
C
C
C
C
C
C
Clean the air filter periodically.
When cooling season is
over,clean the air filter.
If air filter is colgged:
Efficiency of air-conditioning is
reduced, and it will result in
excessive consumption of elec-
tric power.
It will result in malfunction.
Water drop will drip in cooling
mode Operation.
reduced, and it will result in
excessive consumption of elec-
tric power.
It will result in malfunction.
Water drop will drip in cooling
mode Operation.
Keep the room temperature to be suitable.
Too cooling is not good for your health. Furthermore, it
will result in excessive consumption of electric power.
Optimal
temperature
Prevent direct sunlight and draft.
Adjust the blow direction cleverly.
Use circulator when coldness is
felt on your feet during the heat-
ing operation.
Intercept direct sunlight with the cur-
tain or blind during cooling. Keep the
window and entrance shut except dur-
ing ventilation.
Avoid facing the cooled air directly for a
long time. Care also should be exercised
to avoid the wind directly to small ani-
mals or plants.
If you feel cold on the feet because of
high ceiling, it is recommended to use
the circulator.
For details, contact your dealer.
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similar qualified person. An extend cord is not recommended, the requirement of the power supply
cord is H07RN-F 3G 2.5mm
2
(suitable for installation in European region)
3. If the fuse on PC board is broken please change it with the type of T. 3.15A /250V.
4. The waste battery shall be disposed properly.
5. The wiring method should be in line with the local wiring standard.
6. Use copper wire only. The connecting cable should be H07RN-F 2x2mm
2
, H05RN-F 4G 0.75mm
2
.
The power cable should be H07RN-F 3G 2.5mm
2
. All the cables shall have got the European
allthentication certificate.
7. The power supply connects from the indoor side.
8. The all-pole discon-rexion connection method should be applied in the power supply.
9. The indoor unit installation height is at least 2.5m
1. Applicable ambient temperature range:
Cooling
Heating
Indoor
Indoor
Outdoor
D.B
32 / 23
18 / 14
18 / 14
Maximum:
Minimum:
Minimum:
D.B / W.B
D.B / W.B
D.B / W.B
Maximum:
Minimum:
Minimum:
D.B / W.B
D.B
D.B
Maximum:
Minimum:
Minimum:
D.B
20
27
Outdoor
D.B / W.B
Maximum:
Minimum:
Minimum:
D.B / W.B