Disc Makers autograph pro Guida Utente

explained within the Cartridge button description of

section 3-D in the manual to clean the cartridge nozzles.

Also, you must perform a bidirectional calibration prior to

printing; see the description in Section 3-D after you have

installed the printer driver.

6.  Connect the printer to your computer using the proper

interface cable. For best results, use a IEEE 1284-Compliant

cable and do not connect to an A/B switch box. Also, note

that the printer will print fastest if your computer’s

parallel port is set to ECP mode (most new computers are

set to ECP). Your computer’s manual will have information

on changing the parallel port mode if you need to switch it

to ECP.

SOFTWARE INSTALLATION

Once you have set up your printer, you must then install all of

the appropriate software required for printing. The included

CD contains all of the necessary software. At a minimum, you

must install the printer driver appropriate for your computer’s

specific operation system (Windows

®

95/98/Me or Windows

2000/XP). Below is a description of the CD contents as well as

installation instructions for each software component.

CD Contents:
• CD Color Printer Pro Driver for Windows 95/98/Me
• CD Color Printer Pro Driver for Windows 2000/XP
• 32-Bit Print Spooler for Windows 95/98/Me (provides

optimum print processing under Windows 95/98/Me)

• 2 Sample CD Designs (TIFF format)

Installation Instructions:
Windows 95/98/Me or Windows 2000/XP Printer Drivers:
1. Insert the included CD into your computer’s CD-ROM

drive.

2. Click on the Start button on the task bar, point to Settings,

and select Printers.

3. Double-click on the Add Printer icon. This will launch the

Add Printer Wizard. Click Next, then click Next again.

4. Click the Have Disk button.

510119.qxd  11/15/01  3:19 PM  Page iv